FORMWORK FOR BRIDGE DECKS AND CAST IN-SITU OR PRECAST VIADUCTS

FORMWORK FOR THE IN-SITU CASTING OF CANTILEVER SEGMENTS

Equipment for the in-situ casting of viaduct segments for big span bridges, cable stayed or not.
A particular attention is placed on the dimensioning of these machines, the weight of which has an influence on the cost of the bridge itself.
Usually the sections are box-shaped with one or more cells.
The forwarding of the outer form happens independently from the inner one.
The movements are handled by a hydraulic plant, fit for guaranteeing the maximum safety of the operators as well as the maximum efficiency of the equipment.


 

FORMWORK FOR THE PRODUCTION OF PRECAST SEGMENTS

We produce formwork for the different types of decks that can have different sections according to the span to be reached and to the requirements for which they have been designed.
Usually, the production rate of a formwork is one segment per day.
The production technique named “match-cast” can be performed either on short forms, “short line”, or on long forms, “long-line”.
Our experience comes from the production of formwork for more than 200 projects of this kind.


 

FORMWORK FOR THE PRODUCTION OF FULL SPAN BOX GIRDERS

Formwork for the production of prestressed or post-tensioned full span box girders.
We have fabricated formwork for the production of girders up to 50 m in length, 16 m in width, and up to1500 Tons in weight.
The pull-heads we produced have reached up to 5000 Tons capacity.
One form, equipped with appropriate accessories, can produce one girder every two days.
All movements are performed by a relevant hydraulic plant, which guarantees quick maneuvers and the safety of the operators.


 

FORMWORK FOR THE PRODUCTION OF GIRDERS FOR MONORAILS AND MAGLEVS

Formwork for the production of monorail girders.
The flexibility of our forms enable the production of both straight and curved girders, with a radius as small as 50 m.
A hydraulic plant manages all movements.
These forms can be equipped with electric or pneumatic outer vibrators, , according to the client’s requirements.
Thanks to software developed by our company, it is very easy to set the formwork to its correct position. The reduced setting times, together with our production arrangement, enable the casting of one girder per day on each of our forms.


 

FORMWORK FOR THE PRODUCTION OF BRIDGE GIRDERS

We design and fabricate forms for any kind of girder : prestressed, post-tensioned, “I”-shaped, “T”-shaped, box shaped, monolithic or segmental, in any length or height.
Opening and closing of the formwork is controlled by means of a purpose-built hydraulic plant.
These forms can be equipped with electric or pneumatic vibration plant, according to the client’s requirements.